Truflo threads

Truflo threads form the characteristics of a tap
Because there is no flow faucet design, improve the thread quality and strength; Allow greater fastener strength in threaded products.
The speed can be increased to twice the traditional cut… There’s more tapping every hour.
Thread forming (through thread cutting) eliminates expensive and time-consuming chip cleaning and processing.
Improved tap life, even abrasive materials… There is no cutting edge to dull.
The lubrication groove allows air and lubricant to be used during tapping.
It is impossible to reduce the tapping at the bottom of the defective blind hole with sufficient chip clearance.
It can be used for various surface treatments to optimize the life and cutting performance of taps.
The popular tru-fogg is shipped within 24 hours
The faucet features a spiral groove design rather than a traditional one
The recorder.
The tap function of the spiral groove helps to remove the chip from the threaded hole.
A spiral groove is recommended when a gap is in the hole, such as a keyway or a cross hole.
Can usually be in a slow spiral (18 to 30 ° spiral Angle) or fast spiral (45 to 52 ° spiral Angle).
Here are some tips on how to screw up the various materials:
Spiral flute of 45 ° and higher – effective very ductile materials such as aluminum and copper. If used in other materials, they usually cause the chip to be nested because the spiral is too fast and the chip is too small to form properly.
The spiral flute 38 ° – 42 ° suggest long-term high carbon steel or free processing of stainless steel. They form a sufficiently tight chip that can be easily evacuated. On the larger faucet, it can ease the cutting.
Spiral flute 25 °, 35 ° – free recommended processing, low or leaded steel, bronze or brass free processing. The spiral grooves used in brass and hard bronze are usually not very good because small pieces don’t blow the spiral well.

Post Your Comment Here

Your email address will not be published. Required fields are marked *